sharkbad.blogg.se

Teradici pcoip zero client disable build to lossless
Teradici pcoip zero client disable build to lossless












When this setting is configured, the setting is used as the endpoint's maximum bandwidth constraint in kilobits per second. When this setting is disabled or not configured on an endpoint, the endpoint imposes no bandwidth constraints. For example, setting a 4Mbit/s maximum bandwidth forces the agent to transmit at a lower rate, even though the setting is configured on the client. It forces the client and agent to use the lower of the two values that are set on the client and agent side. Setting this value prevents the agent from attempting to transmit at a higher rate than the link capacity, which would cause excessive packet loss and a poorer user experience. a single PCoIP session) that connects through a 4Mbit/s Internet connection, set this value to 4Mbit (or 10% less than this value to leave some allowance for other network traffic). For example, with a single user VDI configuration (e.g. Set this value based on the overall capacity of the link to which your endpoint is connected, taking into consideration the number of expected concurrent PCoIP sessions. The bandwidth includes all imaging, audio, virtual channel, USB, and control PCoIP traffic.

teradici pcoip zero client disable build to lossless

Specifies the maximum bandwidth, in kilobits per second, in a PCoIP session. This setting takes effect when you start the next session. Configure the maximum PCoIP session bandwidth ¶ Directive Build-to-lossless is recommended for environments that require images and desktop content to be built to a lossless state.

teradici pcoip zero client disable build to lossless

In network environments with constrained bandwidth, turning off build-to-lossless can provide bandwidth savings. When build-to-lossless is turned off images and other desktop content may never build to a lossless state. Specifies whether to turn the build-to-lossless feature of the PCoIP protocol off or on this feature is turned off by default.

teradici pcoip zero client disable build to lossless teradici pcoip zero client disable build to lossless

Configure the maximum PCoIP session bandwidthĬonfigure the PCoIP session bandwidth floorĮnable/disable audio in the PCoIP sessionĬonfigure the PCoIP session audio bandwidth limitĬonfigure PCoIP Security Certificate SettingsĬonfigure PCoIP USB allowed and unallowed device rulesĬonfigure Proxy Access to a remote License ServerĬonfigurable Settings ¶ Configure build-to-lossless ¶ Directive














Teradici pcoip zero client disable build to lossless